Publicité
Assembly instructions
®
SEKURANT
Type A anchor device in accordance with DIN EN 795:2012 and DIN CEN/TS16415:2017 for attaching personal
protective equipment against falls from a height.
for dowelling onto a reinforced concrete structure
PRELIMINARY REMARKS
Before installing the SEKURANT
building regulations must be complied with. A load of up to 8kN (depending on the design) can occur at the head of the
®
SEKURANT
props.
Attention!
®
The SEKURANT
support must not be used as a transport eye or for slinging loads. Only original parts of the SEKURANT
system may be used. Assembly may only be carried out by qualified personnel. These assembly instructions and the
SECUPOHL safety instructions must be read and understood.
According to DGUV 201-056 and DIN EN 795, 10/2012, an assembly documentation must be prepared. For this purpose,
each installed SEKURANT
roof structure is installed. The photos must be clearly assignable to the anchor point. In particular, the professional
execution of the fastening must be recognisable. The complete documentation must be handed over to the building
owner during the building inspection. It is part of the building inspection and the subsequent regular inspection by an
expert.
Our APP (http://www.app.secupohl.com or in the APP store) is a useful tool for this purpose.
ASSEMBLY
Distances: min. 2.5m from the edge of the building / max. 7.5m from SEKURANT
1. Set up the SEKURANT
roof.
2.
Drill holes with a concrete drill (ø = 12 mm), 85 mm
deep from the top edge of the concrete. Drilling
can be done through the holes of the SEKURANT
foot plate.
3.
Blow out the dowel holes with the enclosed hose.
4.
Insert the dowel into the drill hole by hand or with a
light hammer blow.
5.
Fix the anchor by hand or by light hammer blows in
the anchor bolt with a torque of 60 Nm. Use a
torque spanner.
Requirements
Concrete grade: min. C20/25
Concrete thickness: min. 140mm
Edge distance:
SKYLOTEC GmbH | Im Mühlengrund 6-8 | 56566 Neuwied | Tel +49 (0) 2631 · 9680-0 | info@skylotec.de | www.skylotec.com
3
®
supports, the load-bearing capacity of the roof structure must be checked. The technical
®
prop must be given a consecutive number and documented photographically before the
®
parallel to the edge of the
®
min. 150mm
®
®
to SEKURANT
1/1
®
Vs. 01/23
Publicité
