Publicité
Assembling the rear wheels
(fig. H – rear view)
Warning: Note the direction of wheel
travel.
1. Remove the pre-assembled screws (2d) and
washers (2e) on the rear wheel axle. The
washer (2f) may not be removed.
2. Place the wheels (7a/7b) on the rear wheel
axle and fix them in place with the washers
and screws with the aid of the Allen key (27).
3. Put one protective cap (16) on each wheel.
Mounting the chain cover (fig. I)
1. Place the chain cover (11) and (12) in the
frame (1).
2. Attach the chain cover above with three
screws (23) with the aid of the Allen key (28).
3. Attach the chain cover below with four screws
(25) with the aid of the Phillips screwdriver
(27).
Mounting the saddle (fig. J)
1. Place the saddle (10) on the frame.
2. Insert the screws (20) above through the
saddle.
3. Attach the saddle with the saddle bottom
plate (19) and the saddle attachments (18)
from below.
Adjustments
Operation (fig. D)
1. Slide the trim (14) up.
2. Loosen the clip (2a) until the steering wheel
can be slid up and down, and set the steering
wheel at the right height.
Note: Pull the steering shaft (3) out no further
than to the MAX mark.
3. Pull the clip back on and then slide the cover
over the clip.
Saddle position
The saddle can be freely adjusted. Select a suita-
ble saddle position depending on your child's
physical size and screw the saddle on tight.
Make sure that your child can easily reach the
pedals.
Chain tension (fig. K)
Tighten the chain as required. Proceed as
follows:
1. Remove the chain covers (11) and (12) before
tightening the chain.
2. Loosen the screws (1c) using the Phillips
screwdriver (27) and remove the lid (1d).
3. Loosen the four screws (1e) with the aid of the
Allen key (28) and move the pedal axle (1f)
forwards a little.
Note: Leave the screws in place (1e) in the
pedal axle (1f).
4. Tighten the four screws (1e) securely once you
are finished.
The chain is correctly tensed if it can be pulled
upwards10mm and downwards 10mm.
Storage, cleaning
When not in use, always store the product clean
and dry at room temperature. Use only water to
clean and then wipe dry with a cleaning cloth.
IMPORTANT! Never clean the product with
harsh cleaning agents.
Disposal
Dispose of the article and the packaging materi-
als in accordance with current local regulations.
Packaging materials such as foil bags are not
suitable to be given to children. Keep the pack-
aging materials out of the reach of children.
Dispose of the products and the
packaging in an environmentally friendly
manner.
The recycling code is used to identify
various materials for recycling.
The code consists of the recycling symbol
– which is meant to reflect the recycling cycle –
and a number which identifies the material.
Notes on the guarantee and
service handling
The product was produced with great care and
under constant supervision. You receive a three-
year warranty for this product from the date of
purchase. Please retain your receipt.
The warranty applies only to material and
workmanship and does not apply to misuse or
improper handling. Your statutory rights, espe-
cially the warranty rights, are not affected by this
warranty.
With regard to complaints, please contact the
following service hotline or contact us by e-mail.
Our service employees will advise as to the
subsequent procedure as quickly as possible.
We will be personally available to discuss the
situation with you.
Any repairs under the warranty, statutory guar-
antees or through goodwill do not extend the
warranty period. This also applies to replaced
and repaired parts. Repairs after the warranty
are subject to a charge.
IAN: 345896_2004
Service Great Britain
Tel.:
0800 404 7657
E-Mail: proconcept@lidl.de
Service Ireland
Tel.:
1890 930 034
(0,08 EUR/Min., (peak))
(0,06 EUR/Min., (off peak))
E-Mail: proconcept@lidl.de
GB/IE/NI
7
Publicité
