Nibe Contura C520T Mode D'emploi page 20

GB
20
Installation distances
C520T / C520S
Combustible roof
566
INSTALLATION AGAINST COMBUSTIBLE WALLS
Combustible wall
Permitted area for
combustible parts
of the building
400
468
* If the stove is placed on a hearth plate made of glass for example (accessory), the height from the floor is affected by a distance corresponding to the thickness of the hearth plate, for a free standing
glass hearth plate this is 10 mm.
** To prevent discolouration of painted non-flammable walls we recommend that the same side distance as to combustible walls is used.
WHEN INSTALLING TURNTABLE (OPTION) the follow-
ing installation distances do not apply.
See the separate turntable installation instructions.
100
630
Combustible wall
750
The minimum distance in front of
the stove opening to combustible
parts of the building or interior
!
decoration must be at least 1 m.
A separate glass hearth The dimension diagrams only show
plate (accessory) the minimum permitted installation
increases the connection distances for the stove. When con-
height to the chimney necting to a steel flue, also note the
by 10 mm. The spacers safety distance requirements of the
supplied with the hearth flue. The safety distance between
plate are installed on the an uninsulated flue and a combusti-
stove before connection. ble part of the building should be at
least 450 mm.
475
A = height from floor to chimney
140
Ø150
B = height from floor to c/c chimney
C = height from floor to air inlet
35
D = height from floor to lower edge
E = minimum height to sloped
100
Air inlet Ø67
INSTALLATION AGAINST FIREWALLS
800
Fire-retardant wall of
brick or concrete
615
850
Fire-retardant wall of
brick or concrete
168**
450**
connection upwards
connection rear
of hatch
ceiling from the centre of the
chimney