Publicité
Discharging Operations
Only AC devices that are under 200W and DC devices under
120W can be powered or charged using this power station.
These include many small electronics and appliances. Check
the table below for some common devices and their power
requirements.
PRODUCTS
Smart phone
USB port
Laptop
Tablet
USB port
Drone
DC barrel jack
Light bulb
32 inch TV
Mini fridge
DC barrel jack
NOTE:
• Average power consumption as measured on loads tested
under regular operating conditions. Rated power may be
different from average power consumption.
• Runtime measured on tested loads.
• If a high powered device is plugged in (e.g. a large
refrigerator), the charge level will deplete more rapidly
leading to shorter run times. If devices that draw lower
power are plugged in, you will get closer to the rated run
times.
IMPORTANT! The power station is not suitable for use with
certain products and loads. The continuous output wattage
of this product is limited to 307 W total when supplying
backup power from its battery. This limit applies to the total
devices plugged into this power station.
The power station is not sufficient to run devices designed to
produce large amount of heat, like a space heater or a pellet
stove igniter.
POWERING ON THE POWER STATION
Turn on the power station by pressing and holding the
power switch until the LCD screen illuminates to show the
standby mode (Fig. 6).
m
WARNING!
Do not insert a nail, wire, etc. into any ports
or receptacles. Otherwise a circuit short may cause smoke or
fire.
RUN TIME (h)/
PORT
RECHARGES (X)
12X
AC jack
2X
7X
4X
AC jack
15h
AC jack
4h
24h
NOTE: Before plugging in, verify the device is suitable for use
with the power station. All of the power station output ports
have their own max power capacity. Refer to the Technical
Data section to ensure your device is compatible.
Fig. 6
POWERING AC DEVICES
To use the power station to power an AC device, first press
the AC output switch, and connect the plug of the device's
power cord to the AC outlet of the power station. The LCD
screen will light up and show the output (Fig. 7).
LCD Screen (AC
discharging mode)
Fig. 7
AC OUTPUT PROTECTION: If the AC output has a
short circuit or the output is overloaded, the unit will turn
off the AC circuit for protection. If this happens, please
troubleshoot and re-activate the AC output according
to the table below. Some electrical equipment, such as
refrigerators, ice makers, laser printers may require a
peak power to start-up. This peak power may exceed the
power station's output wattage, which will activate the
unit's overload protection mode. Such devices are not
compatible with the unit.
6
LCD Screen
(standby mode)
Power switch
AC output
switch
Publicité
