Publicité
About the dishwasher control panel.
You can locate your model number on the tub wall just inside the door. Throughout this manual, features and appearance may vary from your model.
PDW8100 Series–PDW8900 Series
PDW9200 Series–PDW9900 Series and CDW9000 Series
A
B
NTI-
ACTERIAL
C
OOKWARE
N
ORMAL
2
Control Settings
1
Status Indicator Lights
The Status display tells you what is happening while the dishwasher is in operation and may flash,
indicating a malfunction. The lights will come ON indicating the sequence of the dishwasher operation.
LOW DETERGENT Displayed when the SmartDispense
ADD-A-DISH Displayed during prewash, indicating that dishes added now will still be cleaned.
2
Time Remaining Display
During operation, the display shows the minutes remaining until the cycle is complete. The display may
adjust the remaining time while the Sensing light is on. The time displayed at the start of each cycle may
change from the factory setting as the unit customizes itself to home use. During a delay start, the display
will show hours of time remaining until the cycle starts.
3
Selections
PDW8000 Series: Press the pad for the desired wash cycle.
CDW9000 Series and PDW9000 Series: Use the Arrow Pads
NOTE: All cycle times and water usage information contained in the following section are approximate
values. Actual results will depend on several factors, including but not limited to inlet temperature,
household water pressure and amount of soil in the wash water.
The light above or next to the selected pad will be ON to indicate which WASH CYCLE has been selected.
4
1
6
*
3
S
C
S
R
W
PEED
YCLE
INGLE
ACK
ASH
C
HINA
C
YCLE
R
INSE
O
NLY
P
C
LASTIC
YCLE
3
(Indicators vary by models)
dishwasher detergent.
NOTE: If you are not using SmartDispense
LED light off, press the ADDED HEAT pad 5 times within 3 seconds. You will hear 3
beeps; then the light will go off. You can turn the light back on by pressing the ADDED
HEAT pad 5 times within 3 seconds.
SENSING Displayed while the Clean Sensor
of water. The dishwasher will adjust the selected cycle to achieve optimal performance.
WASHING Displayed during prewash, main wash and rinse periods.
RINSING Displayed during rinse periods.
DRYING Displayed during HEATED DRY.
SANITIZED Displayed when cycle has met sanitization conditions.
CLEAN Displayed when a wash cycle is complete.
(on some models)
5
4
4
TM
needs to be refilled with liquid or gel automatic
TM
and you want to turn the LOW DETERGENT
is measuring the amount of soil and temperature
TM
to scroll through the wash cycles.
2
1
5
Smart Dispense
LOW DETERGENT
D
RYING
S
ENSING
S
ANITIZED
W
C
ASHING
LEAN
6
Publicité
