Publicité
ATMOSLED Z SERIES
OUTDOOR LED LIGHTING
Assembly, operation, and maintenance instructions
Contents of the box
Safety instructions
Read the instructions.
Save these instructions.
Heed all warnings.
Installation and maintenance must be
pursuant to country standards).
This Class II light does not require grounding.
Verify that the mains voltage coincides with
the light's.
Do not use the product in the event there
are any defective electrical or mechanical
components.
it should be replaced exclusively by the
manufacturer, its tech support, or by a
risks.
It does not require interior cleaning. Do not
Symbols
Directive 2011/65/EU (RoHS) Free of
hazardous substances.
Class II isolation: Double electric
insulation that does not require
protective grounding.
Directive 2012/19/EU (WEEE). Waste
from electrical and electronic
equipment waste.
Do not alter the light under any circumstances. When repairing or replacing it, always use original spare parts provided by the manufacturer.
The product warranty will be voided in the event of any failure to comply in full or in part with these instructions.
No.
WEIGHT
REF.*
LEDs
(kg)
680902
12
5,9
xxxxxxxx
681902
24
7
xxxxxxxx
36
7,2
682902
xxxxxxxx
48
8,4
683902
xxxxxxxx
685902
72
9,8
xxxxxxxx
Operating temperature: -35... 40ºC / Refs.685902
Input volt.:
/ PF>0.96 Optic:
dimming, color temperature, type of optic, and color.
Assembly parts
a
M8
b
open the light under any circumstances.
The colors of the cables in the conductor
correspond to the following:
BLUE - NEUTRAL
BROWN or BLACK - PHASE
The manufacturer accepts no liability for
damages caused as a result of improper
connections with regard to the above-
mentioned color code set out in the REBT
(low voltage electrotechnical regulation).
Disconnect the light's power to replace the
optics and, where applicable, to replace the
polycarbonate protector in the event of wear
and tear.
Do not loosen the light's seal under any
circumstances or its watertightness may be
compromised.
The light source of this light cannot be
IP66 protection against the
IP66
penetration of solid foreign objects
and water.
IP68
IP68 protection against the
penetration of solid foreign objects
and water.
TOTAL POWER
L
CONSUMPTION
(mm)
(W)
260
40
340
60
340
77
388
109
510
148
xxxxxxxx
: -35... 35ºC
thick / *xxxxxxxx depends on
option 1A:
WALL SUPPORT
THB.391.A2A connector
Ref. 69000801
+
option 1B: ARM
Horizontal support
Ref. 69000201
M8
option 1C: ARM
Vertical support
Ref. 69000401
Double vertical support
c
d
e
Ref. 69000601
replaced. When the light source reaches
the end of its life, the entire light must be
replaced.
In the event of accidental opening, the joints
of the covers must be replaced to ensure
IP66 protection.
The light must be placed so that it will not
be looked at directly at distances less than
Assembly systems must be according to
the luminaire weight. They must be able to
bear 5 times the weight of the luminaire –
including its own weight in Kg.
IK10
Ref. 69000801
L
423
Ref. 69000401
L
395
IK10 protection against harmful
mechanical impacts.
Do not look directly at the light for
long periods of time.
requirements.
Ref.69000201
L
472
L
Ref. 69000601
703
(mm)
EN
Publicité
