Satco NUVO S13140 Manuel D'installation

HI-PRO LED SMART PORT LAMPS
Models: S13140, S13141, S13142, S13143, S13144, S13145
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING:
Risk of Fire or Electric Shock
• Luminaire wiring and electrical parts may be damaged when drilling for
installation of LED retrofit. Check for enclosed wiring and components.
• LED Retrofit installation requires knowledge of luminaires electrical systems.
If not qualified, do not attempt installation. Contact a qualified electrician.
• Install this lamp only in luminaires that have the construction features and dimensions
shown in the photographs and/or drawings and where the input rating of the retrofit
does not exceed the input rating of the luminaire.
• Do not make or alter any open holes in an enclosure of wiring or electrical
components during kit installation.
• To prevent wiring damage or abrasion, do not expose wiring to edges of
sheet metal or other sharp objects.
• Disable all power to the Luminaire. The lamp holder must be disconnected from
the wiring to the ballast, capacitor, or ignitor. Verify that voltage does
not exceed 277V AC. Please see "Wiring Diagram".
• Failure to follow instructions can result in a damaged product
and will void warranty. It could also result in an electric shock or fire.
IMPORTANT:
• Added weight of the device may cause instability of a free-standing portable luminaire.
• Installers should not disconnect existing wires from lampholder terminals to make new
connections at lampholder terminals. Instead installers should cut existing lampholder
leads away from the lampholder and make new electrical connections to lampholder
lead wires by employing applicable connectors."
WIRING DIAGRAM:
Replacing CFL Lamp
(L1)
CFL Wiring Diagram
Replacing HPS/HID Lamp
Capacitor Ignitor
(L1)
HPS/HID Wiring Diagram
© Copyright 2020 Satco Products, Inc. 9/20
SALE on SATCO at www.BulbAmerica.com
take additional 5% Off with coupon code 5PDF
(L1)
Hi–Pro Wiring Diagram
Capacitor Ignitor
(L1)
Hi–Pro Wiring Diagram
Fig. A
Color
temperature
selection
switch
Color Temperature
Intelligent
interface
port for
accessories
INSTALLATION:
Step 1: Turn off the power before installation.
Step 2: Remove the old Ballast, Capacitor
and Ignitor (if existing).
Step 3: Make sure Alternating Current Wires
connect to the socket directly.
Reattach or replace ground lead (if necessary).
Step 4: Select color temperature on
lamp (Fig. A).
Step 5: Screw the LED lamp into the
corresponding socket. Attach retrofit label
to luminaire.
Optional Hi-Pro Intelligent Interface Accessories:
80-954
WiFi Module
80-956
Photocell
80-955
Motion Sensor/PIR
80-957
Motion Sensor/MW
Satco Products, Inc.
Brentwood, NY 11717