Technical Data; Operating Instructions - SKF 729659 C Mode D'emploi

2.1

Technical data

Voltage
Power
Temperature range
Temperature accuracy
Plate dimensions
Height of lid
Outside dimensions
Length of connection cable
Weight
Designation
3.

OPERATING INSTRUCTIONS

a) Make sure the voltage marked on the heater corresponds with the
one available from the main supply.
b) Connect the heater to the power supply. For certain markets the
correct plug might have to be attached in order to fit the electrical
socket.
c) Set the thermostat to the required temperature.
Recommended temperature for bearings is 110 °C (230 °F).
d) Turn the unit on by pressing the ON/OFF switch. Main pilot lamp will
light up.
e) The second pilot lamp is lit while the hot plate is being heated but
switches off as soon as the selected temperature has been reached.
f) The temperature of the hot plate will remain within 10 °C (18 °F) of
the selected value.
8
230 V, 50/60 Hz or 115 V, 50/60 Hz
1,000 W
50 - 200 °C (120-390 °F)
better than 10 °C (18 °F)
380 x 178 mm (15 x 7 in)
50 mm (2 in)
400 x 240 x 130 mm (16 x 10 x 5 in)
2 m (6.6 ft)
4.7 kg (10 lb)
729659 C (230 V model)
729659 C/110V (115 V model)
Electric Hot Plate SKF 729659 C