Publicité
l
Assembly (continued)
4
Attaching the crossbar
Attach the center lengthways bar (E) with the hole side to the center of the connector bars (A & B) without the magnet iron plate,
using M6x80 bolts (DD) and washers (EE).
Attach another side of the center lengthways bar (E) to the center of the back connector bars (A & B) using M6x80 bolts (DD),
M6X15 bolts (AA) and washers (EE).
Attach the lengthways bar (C) to the assembled connector bars (A & B) using M6x80 bolts (DD),
Repeat this step for another three
Once all bolts are in place, fully tighten all the bolts by the hex wrench (GG).
Make sure three red circled holes on top bars (D) and center lengthways bar (E) must stay
on the same side to allow assembling the protective cover (I) later on, then attach to the
assembled connector bar (A&B) which is without Magnet iron plate (K) as shown below.
Q
A
The hole is to lock the
protective cover (I)
Le trou sert à verrouiller
la couverture de protection (I)
EE
AA
L
A&B
lengthways bars (C) and two side top bars (D).
.
DD
A
E
C
D
B
EE
D
EE
S
B
A&B
E
8
M6X15 bolts (AA) and washers (EE).
DD
EE
AA
C
B
C
DD
Q
A
K
EE
D
A
EE
AA
EE
B
Publicité
