Publicité
SETTING UP YOUR MAJORITY D40 SPEAKERS
EN
Please note that the instructions in this manual will refer to the speaker or remote
control button number e.g (Ref.*number*) in accordance with the diagrams on pages
2-4.
Connecting and powering the unit
Using the power cord provided, plug one end into the back of the primary speaker
(Ref.12) and plug the other end into a mains socket. Switch the unit on at the back of
the primary speaker (Ref.11).
Connect the two speakers together via the speaker connector cable (Ref.8). To do this,
plug the left speaker connector cable plug into the right (primary) speaker connector,
which reads ('To L speaker') (Ref.9).
Switch on your Majority D40 Speakers
⏻
Press the
button (Ref.16) or press and hold the 'Mode' button on the unit (Ref.3) to
⏻
switch on the speakers. Press the
button (Ref.16) to switch the speakers off.
Remote Power
Remove the battery cover of the remote control. Insert 2 x AAA batteries (included).
Replace battery cover.
Note: when using the remote control, ensure that you are pointing at the remote sensor
(Ref.1) otherwise the unit may not respond to keypresses.
7
Publicité
