Publicité
6. Press 6(DRAW) to draw the graph.
•
Drawing the graph causes a vertical cursor to appear on the display, as shown on the
screenshot below. Use this graph to specify the range of the sound output from the
speaker.
7. Use the d and e keys to move the vertical cursor of the output range start point and
then press w to register the start point.
8. Use the d and e keys to move the vertical cursor of the output range end point and
then press w to register the end point.
•
Setting both the start point and end point will cause the Output Frequency dialog box
shown below to appear.
9. Specify the output frequency percent (%) value.
•
To output the original sound unchanged, specify 100 (%). To output a sound one octave
higher than the original sound, input 200 (%). To output a sound one octave lower than
the original sound, input 50 (%).
10. Input a percent (%) value and then press w.
•
This outputs the sound of the waveform within the selected range.
•
If the specified result cannot be output as a sound, the message "Range Error" will
appear. If this happens, press J to display the screen shown below and change the
settings.
11. To stop sound output on the EA-200, press the [START/STOP] key.
12. Press w.
•
This displays a screen like the one shown below.
ε
-7
Sampling Screen
R
Publicité
