Package Contents; Assembly - Ariens Sno-Thro 921 Série Manuel Du Propriétaire/Utilisateur

WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
WARNING: Dropping or tipping
over boxed unit could result in
personal injury or damage to unit.

PACKAGE CONTENTS

921013, 022, 023, 031
4
1
1. Sno-Thro Unit
2. Discharge Chute
3. Chute Crank
4. Literature Pack
5. Fuel Cap (Packaged Separately)
(921013)
2 3
OS7021
Figure 3

ASSEMBLY

2
5
5
1. Sno-Thro Unit
2. Discharge Chute
3. Chute Rod
4. Literature Pack
5. Chute Control Assembly and Cable
6. Fuel Cap (Packaged Separately)
ASSEMBLY
Tools Required:
• Pliers
• Open-End Wrenches: 3/8, 7/16, 1/2,
9/16 in. and/or Adjustable Wrench
• Tire Gauge
Unfold Handlebar
(Figure 5)
1. Remove the lower and loosen the upper
hardware on the handlebar assembly.
2. Loosen the hardware on the shift rod.
3. Put the speed selector lever in the
second reverse position.
4. Rotate the handlebars into operating
position.
IMPORTANT: Be careful not to damage cable
spring hooks when rotating handlebars
upward.
5. Install and tighten all hardware on the
handlebar assembly and shift rod.
6. Check tension on auger and traction
clutch cables.
GB - 8
921017, 018
3
4
1
(921018)
Figure 4
6
OS7019