Aldor Automotive CIT1JYSU Instructions De Montage

Citroën Jumpy III 2016-> / Fiat Scudo III 2021-> / Opel Vivaro C 2019-> /
ATTENTION!
To obtain an optimal fixation the ambient temperature during installation should be at least 15°C!
Mounting
1. Check the fit of the spoiler on the car.
2. Use coarse sandpaper to remove the paint on the mounting surface of the spoiler, so that the basic material
becomes visible.
3. Thoroughly clean the mounting surfaces of both spoiler and car with degreaser.
4. Apply the enclosed spoiler glue to the mounting surface of one half of the spoiler (fig. 1).
5. Place the spoiler on the car and position it correctly.
6. Let one person hold the spoiler, so that a second person can carefully open the rear door. Temporarily fix the
spoiler with tape. Pull the tape from the spoiler around the edge of the rear door (fig. 2), so that any gaps are
minimised. Any squeezed-out rests of glue must be removed IMMEDIATELY with degreaser!
7. Repeat steps 4 tot 6 for the other half of the spoiler and make sure both parts fit flush in the middle.
ATTENTION!
•
Allow the glue to dry and do not drive the car for 12 hrs. During 24 hrs no mechanical loading should be
applied to the spoiler. Do not wash for 48 hrs.
•
No warranty acceptance of any damage due to the use of a car wash.
fig. 1
fig. 2
ASSEMBLY INSTRUCTIONS
Peugeot Expert III 2016-> / Toyota ProAce II 2016->
Roof spoiler for models with twin rear doors
Art.nr. : CIT1JYSU
FIA1SCSU
OPE1VISU
PEU1EXSU Peugeot Expert III 2016->
TOY2POSU Toyota ProAce II 2016->
Material : PU
Parts list :
Part
Roofspoiler
Tube PU glue
Required tools:
- sandpaper
- degreaser
- tape
glue / Kleber / lijm / colle
Van Hilststraat 4
5145 RL Waalwijk
The Netherlands
tel: +31-416-344 778
fax: +31-416-344 984
www.aldorautomotive.com
Citroën Jumpy III 2016->
Fiat Scudo III 2021->
Opel Vivaro C 2019->
Qty
1
1
A448-HANDLEIDING.docx-D / Rev. 0