Accessories - PRO-PULSE CT119-C Manuel De L'utilisateur

SPECIFICATIONS
Drill
3/8" (10 mm) keyless chuck

No-load speed : 0 - 600 RPM

Variable speed reversible trigger with electric brake

Bright LED work light

LCD battery indicator

Magnetic bit holder

Jigsaw
No-load speed : 2,200 SPM

0 - 45° bevel cut

Circular Saw
No-load speed: 3,300 RPM

Blade size : 5-3/8" (137 mm)

0 - 45° bevel cut

LCD battery indicator

Overload protection

Work Lamp
Halogen bulb: 10 watts

90° rotating head with compass


Accessories:

3 - 5 hour charger

2 rechargeable Ni-Cad batteries

2 double-ended screwdriver bits

6 drill bits

8 x 1" (25 mm) screwdriver bits

4 sockets

Magnetic bit holder

Socket holder

2 jigsaw blades

Hex wrench for jigsaw

Circular saw blade

Hex wrench for circular saw

Rip guide

OPERATING NOTES FOR BATTERY PACK
Battery must be fully charged for a minimum of 6 hours before using tool.
1.
Batteries will reach full performance after about five charge/discharge cycles.
2.
3.
Always have tool switch in neutral/lock position when removing or
inserting battery to avoid unintentional starting.
4.
To remove battery pack from the tool, press the lock spring buttons and pull
out.
5.
To insert, simply push pack in until lock spring clicks.
6.
The battery charger consists of two parts:
a combined transformer/110 volt plug with a low-voltage lead

a charging stand

To charge, connnect the transformer/plug low-voltage lead to the charging
7.
stand.
Insert the transformer/plug into a 120V household current receptacle.
8.
9.
The step of the battery pack has positive and negative terminal marking on it.
Align these with the identical markings on the top of the charging stand and
insert pack into base (Pack will not insert properly if reversed)
10. The red light is the charge indicator. When the charger is connected to AC
household current, the red light remains off.
11. When the battery is properly inserted into the charger and charging, the red
light is on.
20
CT119-C