Publicité
TYRE STAND
˜ Introduction
We congratulate you on the
purchase of your new product. You
have chosen a high quality product.
Familiarise yourself with the product before
using it for the first time. In addition, please
carefully refer to the operating instructions and
the safety advice below. Only use the product
as instructed and only for the indicated field of
application. Keep these instructions in a safe
place. If you pass the product on to anyone
else, please ensure that you also pass on all the
documentation with it.
˜ Intended use
The tyre stand is intended for the storage of
wheel rims with or without tyres. This product is
not intended for commercial use.
˜ Description of parts
Central linking piece
1 ]
[
Spring washers x4
2 ]
[
Screws x4
3 ]
[
Down rod section (without plug)
4 ]
[
End rod section (with plug)
5 ]
[
Extension legs x4
[
6 ]
Plate x4
[
7 ]
Integrated pin x4
[
8 ]
Tread depth gauge
9 ]
[
Air pressure gauge
10 ]
[
Tyre protection cover
[
11 ]
Tyre chips x4, 4 different colours
12 ]
[
Hexagon wrench
13 ]
[
˜ Technical data
Suitable for all currently available car rims up to
18 inches (approx. 46 cm).
Suitable for all common car wheel rims with tyre
widths up to 225 mm (225/55 R18).
Material:
Total height
(without container):
Weight
(without accessories):
Max. load capacity
(4 wheels):
Max. load per disc:
˜ Accessories
Tyre protection cover
With hook-and-loop tape fastening
Tyre chips
[
12 ]
In 4 different colours.
Labelling: front left, right front, left rear, right
rear
Air pressure gauge
For easy measurement of air pressure.
Measurement range:
Tread depth gauge
Measurement range: 0 to 20 mm; shows
statutory minimum tread depth (1.6 mm) and
recommended tread depth for winter tyres
(4 mm).
The required profile measurements may vary
by country. Therefore please find out about the
specific regulations in your country.
Safety information
Do not tilt the tyre stand!
WARNING!
RISK OF INJURY TO
PERSONS! DANGER OF TIPPING!
WARNING!
The type stand must be set
up on a solid and even ground before use.
The base must not slope, as the stability of
the rack cannot then be guaranteed (use
spirit level to check).
The tyre stand may not be used for any
other purpose since this could cause injury.
Steel, aluminium,
PP (polypropylene)
approx. 1 m
approx. 2.65 kg
100 kg
25 kg
11 ]
[
10 ]
[
0.7 to 3.5 bar /
10 to 50 psi
9 ]
[
GB/IE/NI
5
Publicité
