Publicité
Information of the acoustic
power level LWA in dB.
Class. II -Double insulated
WARNING: Packaging materials are not toys!
Children must not play with plastic bags! Danger
of suffocation!
ELECTRICAL SAFETY
Always check that the
supply corresponds to the
voltage on the rating plate.
DESCRIPTION
This model is intended for infrequent use by
homeowners, cottagers, and campers, and for
such general applications as clearing, pruning,
cutting firewood, etc. They are not intended for
prolonged use.
It is not designed for commercial use.
1. Rear grip
2. Front grip
3. Front finger guard / Chain break
4. Saw chain
5. SDS system
6. Guide bar cover
7. Guide bar
8. Rear finger guard
9. Power cable
10. Claw stop
11. Safety lock- button
12. Cable hook
13. ON/OFF switch
14. Oil tank cap
15. Oil gauge
16. Chain wheel
17. Guide bolt
40cm = Cutting
length
46cm = Chain guide
length
power
MOUNTING THE CHAIN
Important: The front finger guard (3) must
always be in the top (vertical) position.
The guide bar and saw chain are supplied
separately. To assemble, first unscrew the lock nut
(5) and remove the guide bar cover (6). The guide
bolt (17) must be in the centre of the guide. If
necessary, adjust the chain tensioning with the
chain wheel (16).
Before assembling the guide bar with the saw chain,
check the cutting direction of the teeth!
The running direction is marked with an arrow on
the cover (6).
To determine the direction of cut, it may be
necessary to turn over the saw chain (4). Hold the
guide bar (7) vertically with the tip pointing upwards
and put on the saw chain (4, beginning at the tip of
the bar.
Then assemble the guide bar with the saw chain as
follows:
- Place the guide bar with the saw chain on the
chain wheel (16) and guide bolt (17).
- Place the saw chain round the chain wheel (16)
and make sure it is correctly mounted .
- Place the cover (6) on top and tighten gently with
the lock nut (5). Now the saw chain has to be
correctly tensioned.
62
If the chain saw is already
connected to the power
supply: Pull the plug
from the socket outlet. Wear
protective gloves whenever
doing any work on
the saw chain.
To prevent injury on the
sharp cutting edges, always
wear gloves when
assembling, tensioning and
checking the chain.
Publicité
