Publicité
Horn EQ
The Horn EQ provides a 6dB per octave high frequency boost
that is sometimes required for high frequency horns. The
frequency control sets the low frequency corner of the filter.
To return to the Main Menu, select Discard and Exit or Save
and Exit.
Delay
Delay can be used to align drivers within a loudspeaker or to
delay auxiliary speakers like those installed under a balcony.
A short delay can also be used to delay the main speakers to
align them with the drums or bass guitar. A total of 125 mS of
delay is available on each channel. 5 mS of delay is available
in 41.67 uS steps for driver alignment. 120 mS is available
in 1 mS steps for system alignment. These delays can be
set independently so that the driver alignment offset can be
maintained when the system alignment delay is adjusted.
The first screen in the delay Sub Menu allows the user to
decide whether the delays will be set independently or B=A.
This selection only applies to the 1 mS step system delay,
leaving the driver alignment delays to be set independently.
The IPR2
amplifiers display the equivalent delay distance
™
in meters and feet in the system delay and centimeters or
inches in the driver delay.
Limiter
The IPR2 DSP has limiters available on each channel. These
limit the signal level to the input of the power amplifier
stage. The limit threshold starts at zero and is adjusted in -1
dB steps, reducing the maximum output. You must be aware
the IPR2 DSP works the same as most other amplifiers, as
their maximum output depends on the line voltage and load
impedance. Depending on load, you may need to reduce the
limiter up to 3 dB before the output is reduced.
Memory
The IPR2 has four memory locations where its settings can be stored and then recalled. Each location has a six-character
name to identify the file. The name of the active preset is also displayed in the Main Menu "Memory" screen.
System (mS) Delay screen
Driver alignment (uS) screen
Publicité
