Publicité
XP SBC HC 8372/00-1
Controls
Kit contents
This FM transmitter system consists of the
following accessories:
1 x SBC HC8372 FM transmitter
1 x SBC CS030/00 12Volt / 200mA AC/DC
adapter (for UK: SBC CS030/05 12 Volt/
200 mA AC/DC adapter)
1 x 3.5 mm stereo plug to 2x RCA audio
cable (15 cm)
1 x 3.5 mm plug to 6.3 mm stereo adapter
plug
1 x antenna tube
Controls
Transmitter (figure 1)
1 Power indicator – lights up when audio
signals are detected at the audio input.
2 DC power – connect to the 12 Volt/
200 mA AC/DC adapter
3 3.5 mm stereo transmitter audio
input – the audio cable connects your
FM transmitter to an audio source
4 Channel switch – select one of
2 channels for best reception.We advise
you to select channel 1 as a first option.
5 Controls plate
Environmental Information
All redundant packing material has been omitted.We have done our best to make the
packaging easily separable into two materials: cardboard and polyethylene
Your unit consists of materials which can be recycled if disassembled by a specialized
company. Please observe the local regulations regarding the disposal of packing
materials, exhausted batteries and old equipment.
25-06-2001 18:11
Pagina 5
All manuals and user guides at all-guides.com
Installation
Transmitter power supply
IMPORTANT
Use only Philips SBC CS030/00
12 Volt/200 mA AC/DC adapter.
(For UK, use only Philips SBC CS030/05)
1 Make sure the adapter's rated voltage
corresponds to the mains socket voltage.
2 Connect the DC connector of the AC/DC
adapter to the 12 Volt DC power input
connector located at the rear of the
transmitter.
3 Connect the 12 Volt/200 mA AC/DC
adapter to the mains socket.
– Always disconnect the AC/DC adapter if
the transmitter is not to be used for a
long period of time.
4 Insert the antenna tube in the hole, located
on the top of the transmitter. Ensure that
the wire which is hanging out of that hole, is
guided in the antenna tube.
– Installing the antenna tube correctly, will
improve the transmission range.
5
Publicité
