Publicité
Tip: The brush roll and its cover are washable；Ensure they are completely dried before use
Caution
1. When the dust blocks the air flow of the floor brush，please clean it with a stick
2. Except for the brush roll and its cover, all others can not be washed with water
3. Do not apply oil to both ends of the brush roll
4. Do not touch the working brush roll part and stay away from the air outlet when in operation
5. Do not use when wheels or scrubber's nylon loop are damaged
EROUBLESHOOTING
In case of mini-function,please refer to the following table
Problem
3 lamps for power
indicator flicker
power brush does not
work
Runnning time
shortened
The vacuum has no
suction power
MAX indicator
flickers
No charging
REMOVAL OF APPLIANCES USED
Directive 2012/19/EU on waste electrical and electronic Equipment (WEEE) requires that the
appliance uses are not disposed of using the normal municipal waste. Old appliances must be
collected separately in order to optimize the recovery and recycling of materials they contain and
reduce the impact on human health and the environment.
The symbol of the dustbin is used on all products to remind the obligations for separate collection. Consumers
should contact their local authorities or dealer regarding the steps to follow for the removal of their old appliance. If
you proceed with the scrapping of old equipment, be sure to render useless what could be dangerous: disconnect
Possible causes
The rolling bar is wrapped
Temperature is too high or low
Brush is trapped by hair or larger
debris
Battery needs to be replaced
Ambient temperature is too high or
too low
Battery is no fully changed
The dust cup is full
The filter is blocked
Suction inlet of brush or other
accessory is blocked
Parts of the appliance is not fully
dried after cleaning
The filter or duct are blocked
Ambient temperature when
charging is too low or too high
Solution
Cleaning the rolling bar
Mover the vacuum to suitable temperature
Ensure that no hair or other thread is trapped around
the brush and check brush area for larger debris
Contact the shop or after sales service to replace the
battery fat the user's own cost
Your vacuum should only be operated in suitable
ambient temperature
The battery needs charging
Clean the dust cup after use to prevent build ups
Remove any dust or debris from the filter
Check for blockages at brush and other attachment
points
Ensure that all components are properly dried after
washing
Clean the dust filter,dust cup and air duct
Charge the machine under the right temperature
environment(5℃-40℃)
Publicité
