Publicité
Dismantle LED linght module
Press the left and right buttons at the same time to open the panel and carefully
remove the 2 screws from the lamp plate (a cross headed screwdriver will be needed to
remove the screws).
Disconnect the terminal of LED light. Take the LED light out.(for lamp 2W)
Replace the lamp(commercially available LED lamp).
Lamp type
LED modules,
separate ballast
Reinstall LED light module
Install the LED light on the lamp plate.(for lamp 2W)
Connect the terminal of LED light and light leads.
Carefully fasten the 2 screws on the lamp plate , close the panel.
DISPOSAL OF OLD ELECTRICAL APPLIANCES
The European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE), requires that old
household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old
appliances must be collected separately in order to optimize the recovery and recycling of the materials they
contain, and reduce the impact on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you dispose of
the appliance, it must be separately collected.
Consumers should contact their local authority or retailer for information concerning the correct disposal of
their old appliance.
Max Power
Voltage
2W
DC 12 V
Square / Dimesion:49mm x 199mm
Picture
EN-9
Lamp Cap
ILCOS D code
DSS-2-S-49
——
/199
Publicité
