Publicité
SELECTING THE LANGUAGE
1
Plug in the TV/DVD power cord
Plug the TV/DVD power cord into a
standard AC outlet.
NOTE:
•
If any digits appear in the corner of
the screen, press POWER without
unplugging the power cord.
Make sure ...
•
Press POWER to turn on the TV/DVD.
NOTE: This function effects only the language on
the screen menu and not the audio source.
2
Select "LANGUAGE"
Press SETUP on the remote control.
Press Arrow (K/L) to point to
"LANGUAGE".
3
Select "ENGLISH", "ESPAÑOL" or "FRANÇAIS"
Select "ENGLISH", "ESPAÑOL"= Spanish or
"FRANÇAIS"= French using ENTER.
4
Exit the Language mode
Press SETUP to return to TV mode.
NOTE: If for some reason the menu is in Spanish or
French, press SETUP, press Arrow (K/L) to point to
"IDIOMA [ESPAÑOL]" or "LANGAGE
[FRANÇAIS]", then press ENTER, then press
SETUP on the remote control.
SET UP FOR USE
TV
You can program the tuner to scan all the channels
you receive in your area.
NOTE: Channel memory programming is NOT
needed when connected to a cable box or satellite
box. Just select the TV/DVD channel selector to the
output channel of the cable box or satellite box (Ex
CH3). Then select the channel to be viewed on the
Cable Box or Satellite Box.
Make sure ...
•
Press POWER to turn on the TV/DVD.
1
Press SETUP on the remote control.
- TV SETUP -
Press Arrow (K/L) to point to
CHANNEL SET UP
"CHANNEL SET UP".
V-CHIP SET UP
B LANGUAGE [ENGLISH]
CAPTION [OFF]
Then, press ENTER.
2
Press Arrow (K/L) to point to
"AUTO CH PROGRAMMING".
Then, press ENTER.
The tuner scans and memorizes all
the active channels in your area.
3
The tuner stops on the lowest memorized channel.
•
When AUTO CH PROGRAMMING is activated
where there is no TV signal input, "NO TV SIG-
NALS" will appear on the display after the com-
pletion of the channel scanning.
•
The TV/DVD may memorize TV channels as
CATV channels if reception conditions are poor. If
this happens, check the antenna connections and
try the AUTO CH PROGRAMMING action again,
or wait until reception conditions are better and try
it again.
– 13 –
– 13 –
– 13 –
CHANNEL SET UP
Select "CHANNEL SET UP"
Begin auto ch programming
After scanning
TV SECTION
TV
- TV SETUP -
B CHANNEL SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
CAPTION [OFF]
– CHANNEL SET UP –
ADD / DELETE CH (CATV)
B AUTO CH PROGRAMMING
EN
0C28
Publicité
