Télécharger Imprimer la page

Create Warm Towel Pro Mode D'emploi page 9

Publicité

• Place the heater on a flat stable surface
• Plug into any 220-240V, 50Hz, AC source, then turn on the switch at side, you will hear a
beep sound.
• Turn on the heater by pressing the power button , the LED display will show room temper-
ature, then please use touch control or remote control to set power, temperature and time.
• If the appliance is not used for a long time, switch it off and plug the item out.
Attention: Do not cover the product. The convector should not be placed under a shower or
in a swimming pool.
• The appliance emits a beep upon each operation setting.
TOUCH PAN E L
1. Display
2. PR sensor / Wi-Fi signal control
3. Power on / off
4. Mode
5. Temperature
6. Timer
POWER: When the product is on, press Power. The upper part of the display shows the
temperature. The heater is working at low power heating conditions as default.
• MODE: Press Mode to regulate low, or high temperature power.
TEMPERATURE:
• Press temperature button, the temperature can be set from 5°C to 40°C. Internal tem-
perature is displayed every time the appliance is started up.
• The temperature can be set when the appliance is in stand-by or heating modes. When
the room temperature reaches the set level, the high temperature power stops and the
low temperature power remains active.
• When room temperature is 2 degrees over the set temperature, both the high and lower
temperature powers will stop operating.
• The machine will begin operating again only when temperature decreases 2 degrees
with respect to the set temperature.
TIME: The timer button can be set to start or stop the appliance at the desired time, with
a time interval between 1 hour and 24.
R E MO T E CON TROL
1. Power button
2. Mode
3. Temperature
4. Timer
5. Lock
The touch screen buttons located on the product correspond to the remote control functions.
The Child lock function can be found on the remote control:
CHILD LOCK: Press the child clock button for 3 seconds, the heater is locked and it
can't be switched on. After pressing Child Lock button for 3 seconds again, the heater is
unlocked.
HOW TO USE
1
2
3
4
1
2
3
E NGLI SH
5
6
4
5
9

Publicité

loading