Publicité
Twist the filter top cover on.
NOTE: Before first use, run cold water for 1 minute in "pure" position to flush the filter.
Warning
Do not use with water above 100°F/38°C.
To reduce the risk of property damage due to water leakage, this filter MUST be installed in accordance
with the operating specifications and instructions.
This filter unit must be replaced on regular basis.
Failure to follow instructions and operating specifications will void your warranty. Further, manufacturer
assumes no responsibility or liability for damages arising out of misuse of the product.
Frequently Asked Questions:
1. Q: Why does black water come out after turning on the faucet for the first time?
A: Because the product adopts coconut activated carbon block to filter water, and there are some carbon
particles on the carbon block surface. When it is first used, the carbon particles are flushed into the
purified water to cause black water, which is a normal phenomenon. Please flush it for a minute and then
use it. The purified water cannot be drunk while flushing.
2. Q: Why does the filtered water run quite slowly?
A: The filter cartridge may be clogged. Replace the filter cartridge.
3. Q: Why does the unfiltered water run quite slowly?
A: There may be dirt in filter steel mesh. Clean the filter steel mesh.
4. Q: Why does the water taste funny?
A: The filter cartridge is not installed appropriately, or it should be replaced. Please re-install it in a
correct way. If there is still bad taste, please replace it.
Manufacturer Technical Support
Tel: 1-888-352-3558 (U.S.)
E-mail: service@waterdropfilter.com
Align the slot of filter base with the
slot of mounting base.
Insert filter base into mounting
base and rotate 90° upward.
Made in China V040
Qingdao Ecopure Filter Co., Ltd.
Publicité
