Preparation For Use - Robusta LAVANDA Manuel D'utilisation

EN

PREPARATION FOR USE

1a. Open the Cover of water tank (6) and fill the boiler with about 0.7 litres of water making sure that it
does not overflow.
3a. Connect the power supply cable (7) into an earthed power supply of the correct voltage.
4a. Switch on the steam station by pressing the switch (10), the Indicator light of steam button (5) is on,
make sure the steam button is off and put the iron on the thermal isolated panel.
5a. Check the indicator light of water level (9) is on or off, open the lock of the water tank (6) to refill the
water till the light off.
6a. Push down the tank lock (6) then pull it out ; fill the water accdording to real need. It will be regarded
water empty when less than 60±20g left in the water tank.
NOTE: during the filling operation, be careful that the water does not overflow as it may come out and wet
the surface where the Steam Station is laid.
INSTRUCTIONS FOR USE
STEAM IRONING
1b. Set the iron temperature to the "MAX" steam position, by turning the knob (2). All types of fabric can be
ironed at this temperature.
2b. Wait for the indicator light of steam (5) goes on and the steam button light (8) goes off. Push button
(3) on the iron to release bursts of steam form the holes on the soleplate.
Use the "Steam Holding System"(11) can keep the steam burst without the finger pressure.
Release the button and the steam will stop.
NOTE: during initial operation of the iron, a few drops of water mixed with steam may come out of the
soleplate until the temperature stabilizes. It is advisable to direct the first jets of steam onto an old cloth
until a uniform stable jet of steam is obtained.
_________IMPORTANT__________
• Do not leave the iron unattended whilst connected to the mains.
• Iron only on heat resistant surfaces and on surfaces that allow the steam to escape e. g. mesh ironing
boards.
• The indicator light of steam (5) may go on and off from time to time during use of the Steam Station. This
indicates the machine maintaining the correct and constant pressure and is quite normal.
•If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or similarly
qualified person in order to avoid hazard.
• In the case of breakdown or malfunction do not attempt to repair the appliance yourself but refer to your
nearest authorised service centre.
CARE OF YOUR STEAM STATION
• Before attempting any maintenance operation, be sure to always disconnect the appliance from the
mains.
• Normal tapwater can be used. However, as hard water by its naturee contains limestone, which
may cause a build-up of limescale in the tank, in hard water areas we recommend the use of Vinegar
Solution(75%water+25%vinegar) to clean the tank.
• To clean the body of the appliance, simply use a moist cloth. Do not use solvents or detergents which may
harm the body material.
• We declines liability for any damage or accident derived from any use of the Steam Station which is not in
conformity with the instructions contained in this booklet.
10