Publicité
▪
Saw blades must be kept sharp and in good condition. Replace partially fractured and
broken saw blades immediately.
▪
Work calmly and evenly with the jig saw. You will thus avoid accidents and the saw blades
and the jig saw will last longer.
7
OPERATING INSTRUCTIONS
7.1
Changing the saw blade (Fig. 1)
Releasing the saw blade.
Turn the screws anticlockwise (A).
Insert the saw blade in the ram up to the stop and tighten the two screws of the retention clip.
Important! Make sure the saw blade sits properly in the slot of the roller and ram.
7.2
Switching ON/OFF (Fig. 2)
Switching ON: Press the On/Off switch (3).
Continuous operation: Keep the On/Off switch pressed and lock the On/Off switch with the
locking button (2).
Switching Off : Press the On/Off switch and release.
A: locking button
B: ON/Off switch
7.3
Adjusting the base (Fig. 3)
Remove the vacuum adaptor (9).
Loosen the 2 screws to set the base to an angle up to 45° on the right or left side and re-tighten
the screws.
7.4
Installing/removing the vacuum adaptor (Fig. 4)
If you wish to connect an external dust extraction system (for example, a suitable vacuum
cleaner), you need to mount the supplied vacuum adaptor (9).
7.5
Mounting the vacuum adaptor
▪ Slide the vacuum adaptor (9) as far as possible into the guide rail between the machine and
the adjustable base (7).
▪ Connect a suitable dust extractor/vacuum cleaner (not supplied) to the vacuum adaptor.
7.6
Removing the vacuum adaptor
▪ Disconnect the suction hose of the used dust extractor/vacuum cleaner from the vacuum
adapter (9).
▪ To remove the vacuum adaptor (9), push the handle firmly and pull it out.
8
TECHNICAL DATA
Nominal voltage
Power consumption
No load speed
Cutting depth in wood
Cutting depth in steel
Cutting depth in plastic
Possible angles
Connection type
Copyright © 2024 VARO
POWC20110
220-240 V - 50 Hz
400 W
3000 min
55 mm
6 mm
10 mm
45° - 90°
U&T type
P a g e
| 5
-1
www.varo.com
EN
Publicité
