Publicité
ASSEMBLY
SELECTING THE SANDING SHEET
Depending on the material to be worked and the required rate of material removal,
different sanding sheets are available:
Particle size
Coarse
40
Medium
80, 100, 120
Fine
180 to 400
OPERATION
WARNING! Ensure power source voltage is 120 V. The voltage of the power source
!
must be consistent with the voltage specified on the label of the tool.
SWITCHING ON AND OFF
To start the tool, push the On/Off switch 2 forward so that the "I" is indicated on the
switch.
To switch off he tool, push the On/Off switch 2 toward the rear so that the "0" is
indicated on the switch.
OPERATING INSTRUCTIONS
Note: Do not cover off the venting slots of the tool while working, as this reduces the
working life of your tool.
!
While working with accessories make sure that the covering of the accessories is
undamaged.
OPERATING PRINCIPLE
Due to the oscillating drive the application tool/accessory swings up to 21,000 times
per minute at an angle of 3°. This allows for precise work in narrow spaces.
SAWING
Use undamaged, faultless saw blades only. Deformed, blunt saw blades or saw
blades that are otherwise damaged can break.
When sawing light building materials, observe the statutory provisions and the
recommendations of the material suppliers.
Plunge cuts may only be applied to soft materials, such as wood, gypsum
plaster boards, etc.!
Before sawing with segment saw blades in wood, particle board, building materials,
etc., check these for foreign objects such as nails, screws, or similar. If required,
remove foreign objects.
Material
All wooden materials
Particle and construction
boards
Metal, paint and lacquer
Filler
All wooden materials
Particle and construction
boards
Metal, paint and lacquer
Filler
All wooden materials
Particle and construction
boards
Metal, paint and lacquer
Filler
Application
Coarse grinding/sanding (initial
grinding/sanding)
Remove old coatings, etc.
Fine grinding/sanding
Removal of slight unevenness,
paint spots, etc.
painting
Polishing
19
Publicité
