Publicité
Assembly
A: Upper cover
: Filter
: Bottom base
: Charger
: Hook
across the pool floor. Should an obstacle prevent the robot from
Assembly and operation
Charging the cleaner
Use only the original external adapter and charging cable provided.
Make sure the robot and charger ports are clean and dry before installation.
Charge the robot before using it for the first time (about 5 hours).
1. Remove the pin cover from the charging port located under
the cleaner. To avoid losing the cover, attach the pin cover to
the charging cable.
2. Place the charger plug into the charging port at the bottom
of the cleaner, then plug the charger into the power supply to
begin charging the cleaner.
Note: Once the robot starts charging, the indicator light
on the external adapter will turn red. When the robot is
fully charged, the indicator light will turn green.
3.When fully charged, pull the charger plug out of the
charging port at the bottom of the cleaner. Securely place
the pin cover over the charging port making sure the port
is sealed before placing the cleaner in the water.
E
F
3
A
B
C
D
Bottom cover body assembly bottom
Pin cover
Charging port
Switch
Charger
Publicité
