Publicité
For optimum receiving:
•
Position the receiver so there is nothing obstructing a line of sight to the microphones.
•
Avoid placing microphones and receiver where metal or other dense materials may be present.
•
Remove nearby sources of wireless interference, such as cell phones, two-way radios, computers, media players, Wi-Fi
devices, and digital signal processors.
•
Make sure that the microphone batteries are fully charged.
•
Keep microphones more than two meters (6 feet) from each other.
•
Keep the microphones and receiver more than 5 meters (16 feet) apart.
HANDHELD TRANSMITTER
1. On/Off
Press to turn the handheld microphone on/off.
2. IR Sensor
Infrared sensor for synchronizing frequencies between receiver and transmitter.Rotate the battery
cover to open and expose the IR sensor.
Transmitter function:
•
Open the battery covers of the microphones and install new or full charged batteries inside. Press the
power switch on the microphones. On the receiver: select your transmission channel. Hold the IR
sensor of the corresponding microphone close to the IR transmitter of the receiver. Press the IR
button of the respective channel shortly to synchronize the microphone.
•
When the receiver and the microphone have been synchronized to the same channel, the RF
bargraph on the receiver's display will indicate that a radio signal is being received.
Note: the more bars are displayed, the better the reception is.
•
Reinstall the battery cover onto the microphone again.
BODYPACK TRANSMITTER
1. LCD display
Shows the frequency, channel, battery status and signal.
2. IR sensor
Infrared sensor for synchronizing frequencies between receiver and transmitter.
3. Microphone input
3.5mm microphone input jack for connecting a lavalier microphone.
4. Antenna
5. LED charge indicator
Shows charging status. Red = charging, blue = full charge.
6. Charge port
5V USB type-C charging port.
7. On/off
Press to turn the bodypack microphone on/off.
Transmitter function:
•
Press the power switch on the microphones. On the receiver: select your transmission channel.
Hold the IR sensor of the corresponding microphone close to the IR transmitter of the receiver. Press the IR button of the
respective channel shortly to synchronize the microphone.
•
When the receiver and the microphone have been synchronized to the same channel, the RF bargraph on the receiver's
display will indicate that a radio signal is being received.
Note: the more bars are displayed, the better the reception is.
UHF
No license required
BE
DK
F
HU
IT
NL
PT
RO
SI
CH
GB
Belgium (BE), Denmark (DK), France (F), Finland (FI), Germany (DE), Hungary (HU), Italy (IT), Netherlands (NL), Norway (NO),
Poland (PL), Portugal (PT), Romania (RO), Slovenia (SI), Spain (ES), Sweden (SE), Switzerland (CH), Great Britain (GB)
(excluding geographical restrictions)
FI
DE
NO
PL
ES
SE
4
Publicité
