Publicité
UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging. If the device has been exposed to
drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water might
damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
RECEIVER OVERVIEW FRONT
1. Power On/Off
Switch to turn the device on/off.
2. LCD display
Shows the frequency, channel,
volume and signal.
3. Lock button
Locks the group (1-4).
4. Group button
With this button you can set the frequency by group.
5. IR sensor
Infrared transmitter for synchronizing frequencies between receiver and handheld transmitters.
6. IR button
Button to select the channel to be synchronized with a handheld transmitter.
7. Set
Press to switch between frequency- and volume setting modes. Rotate the rotary dial to select the desired values.
8. Rotary dial
Rotate to change the volume- and frequency values.
RECEIVER OVERVIEW REAR
1. Antenna connectors
2. Mix out
Unbalanced microphone output
connector (6.3mm jack) for
channels 1-4.
3. XLR connector
XLR balanced microphone outputs for connecting to (for example) mixers, power amplifiers or other audio devices.
4. Power input for 12V adapter
Connector for inserting the supplied power adapter.
5. Transmitter charge
USB connectors for recharging the handheld transmitters.
RECEIVER OPERATION
•
Switch on the receiver. The LCD will light up.
•
Select the frequency by pressing the SET button. Turn the rotary dial to the desired setting and then press SET to save. By
pressing SET twice you can adjust the volume level.
•
Pressing the group button allows you to set the desired frequency for the group by rotating the rotary dial.
•
When you press the lock button the group (1-4) is locked and no changes can be made in the settings.
RECEIVER DISPLAY
1. Channel
Shows the corresponding channel.
2. Volume
Shows the volume level of the corresponding channel.
3. Lock
Shows frequency lock status of the corresponding channel.
4. Frequency
Indicates the channels' frequency.
5. RF signal
Indicates the RF signal strength.
6. AF signal
Indicates the audio signal strength.
3
Publicité
