Publicité
EN
Troubleshooting
■ Vector display is strange.
Cause
Magnet is not calibrated.
■ Zero point cal bration fails.
Cause
The crank is subjected to external
force or moving.
■ The Cyclocomputer display is not displaying correctly while I am riding.
Cause
Zero point calibration has failed.
■ There is a rattling noise when I am riding.
Cause
Screws used to install the right
sensor are loose.
■ The magnet is rubbing against the sensor or transmitter while I am riding.
Cause
Foreign objects are attached to
the magnet and rub against the
transmitter or the junction box.
30
Solution
Get the magnet calibrated from the shop where you
purchased the product. Contact with the shop where you
purchased the product.
Solution
Calibrate the sensor in still condition (Page 26).
Solution
Calibrate the sensor if the values in [Force Preview] are
more than ± 4N (Page 26).
Solution
Retighten the screws.
Solution
Clean the transmitter, junction box, and magnet.
Publicité
