Hamilton Beach HBFR726 Manuel Du Propriétaire page 5

Installation Instructions
Location
Two people should be used when moving the appliance.
■
Remove interior and exterior packaging prior to installation. Wipe the outside of the appliance with a soft,
■
dry cloth and the inside with a luke warm wet cloth.
Place the appliance on a floor that is strong enough to support it when it is fully loaded.
■
Do not place the appliance in direct sunlight or near sources of heat, such as a stove or heater, as this
■
can increase electrical consumption. Extreme cold ambient temperatures may also cause the appliance
to perform improperly.
Do not use the appliance near water, for example in a wet basement or near a sink.
■
This appliance is intended for household use only. It is not designed for outside installation, including
■
anywhere that is not temperature controlled (garages, porches, vehicles, etc.).
Before connecting the appliance to a power source, let it stand upright for approximately 6 hours. This
■
will reduce the possibility of a malfunction in the cooling system from handling during transportation.
This appliance is 54.4 cm (21.42 inches) wide by 143.3 cm (56.42inches) high by 54.3 cm (21.38 inches)
■
deep. Make sure that you leave the minimum amount of space between the appliance and all surrounding
walls and vents.
Allow 12.7 cm (5 inches) of space between the back , sides and top of the appliance and all adjacent
■
walls.
This appliance is intended for free-standing installation only and is not intended to be built into a cabinet
■
or counter. Building in this appliance can cause it to malfunction.
.
4
4