Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

INSTALLATION INSTRUCTIONS
TOYOTA CAMRY 2002 -
Hardware Kit
3 – Large Bumpons
6 – 3M Anti-Abrasion Film Pads
6 – Black "C" Clips
6 – # 6 x 3/8" Screws
6 – # 4 x 3/16" Screws
Installation
1.
Be sure that the hood is clean and dry inside and out. Release the hood, but do not open it.
2.
Install one (1) bumpon, in the middle of the hood, 1" up from the Toyota emblem. Install remaining two (2) bumpons, 4
the edge of the hood. See Illustration # 1.
3.
Center the protector on the hood, attach the anti-abrasion film pads under the middle hole on each side as shown in the illustration # 2.
Make sure to cover at least ½" of underside of the hood. See Illustrations # 3.
4.
Slide the "C" clips over the edge of the hood in line with the middle hole in the protector. Be sure that the "C" clips are well seated
against the hood: it may be necessary to tap on the clips. Tighten a # 6 x 3/8" screw through the protector into the top of each clip. Do
not over tighten the screws. See Illustration # 3.
5.
Make sure that the protector is centered on the hood then repeat steps 3 & 4 for the each of remaining holes.
6.
Make sure the "C" clips are all fully seated and the protector is centered then tighten a # 4 x 3/16" screw into the bottom of each of the
"C" clips. Do not over tighten the screws. See Illustration #3.
Note: Do not pull on the protector when opening or closing the hood.
Illustration # 1. – Bumpon Location
4 1/2"
Illustration # 2. – Clips Locations
Clips Locations (Steps # 3 & 4)
Care Instructions
Clean the protector with a mild soap and water solution or plastic cleaner only. Do not use chemicals or solvents.
Periodically check to make sure the bumpon is in place and the protector is secure.
Avoid using automatic car washes. Do not pull on the protector when opening or closing the hood.
Thank you for purchasing a
Retain this sheet for care instructions and hardware kit information.
1"
form fit
hood deflector.
HD 20D 02/ HD 20D 02T
Tools Required
1 – Phillips Screwdriver # 2
1 – Phillips Screwdriver # 1
Illustration # 3. – Clip Configuration
" back from
1/2
Rev1.011002

Publicité

loading

Sommaire des Matières pour FORM FIT HD 20D 02

  • Page 1 INSTALLATION INSTRUCTIONS TOYOTA CAMRY 2002 - HD 20D 02/ HD 20D 02T Hardware Kit Tools Required 3 – Large Bumpons 1 – Phillips Screwdriver # 2 6 – 3M Anti-Abrasion Film Pads 1 – Phillips Screwdriver # 1 6 – Black “C” Clips 6 –...
  • Page 2 Éviter de laver le véhicule dans un lave-auto automatique. Ne pas tirer sur le protecteur pour ouvrir et fermer le capot. Merci de vous êtes procuré un déflecteur FORM FIT. Conserver cette feuille pour connaître les instructions d’entretien et les renseignements concernant le nécessaire d’installation.

Ce manuel est également adapté pour:

Hd 20d 02t