Uline BIG JOE H-4709 Mode D'emploi page 3

OPERATING ISSUE
Steering arm does not
return to the upright
position.
Truck moves forward
when arm is pulled down.
Steering arm jerks
excessively when starting
or stopping the truck.
Drive motor is jerky.
Charger will not turn on.
Batteries will not charge.
PAGE 3 OF 9
TROUBLESHOOTING CONTINUED
PROBABLE CAUSES
Weak return spring.
Binding.
Deadman switch defective.
Short in control head.
Drive wheel worn.
Motor internally damaged or
worn.
Power cord disconnected from
charger.
Charger defective.
Loose connections.
Batteries run too low. Smart
charger cannot detect battery.
1-800-295-5510
Replace spring.
Check and free the binding item. Verify that
the cable has not been damaged. Repair or
replace as needed.
Check for short and repair or replace as
necessary.
Check wiring and repair as required.
Replace drive wheel if worn to within 3/4" of hub.
Replace motor.
Reconnect power cord to charger.
Replace charger.
Check all connections from charger to
batteries.
Jump batteries using a trickle charger.
uline.com
RECOMMENDATIONS
0824 TH-4709