Beper BC.001 Manuel D'instructions page 13

EN
Espresso machine Use instructions
3 - Fill a jug with about 150 grams of milk for each cappuccino to be prepared, you are recommen-
ded to use whole milk at refrigerator temperature (not hot!).
Note: In choosing the size of jug, it is recommend the diameter is not less than 70±5mm, and bear in
mind that the milk increases in volume by 2 times, make sure the height of jug is enough.
4 - Insert the steam wand(with the frothing device) into the milk about two centimetre, then turn the
knob to the " " position , steam will come out from the steam wand. Froth milk in the way moving
vessel round from up to down.
5. When the required purpose is reached, you can turn the knob to the " " position.
Note: Clean steam outlet with wet sponge immediately after steam stops generating, but care not
to hurt!
6. Pour the frothed milk into the espresso prepared, now the cappuccino is ready. Sweeten to taste
and if desired, sprinkle the froth with a little cocoa powder.
7. Press the power switch to cut off the power source.
Note:Before making coffee again.You should turn the knob to the "
" position and press the
steam button to the higher position which is the " " position, the pump will pump water until the
ready indicator is went out then turn the knob to the" " position and wait until the indicator lights
up blue again.
Producing steam to heat liquids
The steam wand (without the frothing device) can be used to make hot beverages like drinking
chocolate, and water.
Method:
1. Remove the detachable tank and fill it with desired water, the water level should not exceed the
"MAX" mark in the tank. Then place the tank into the appliance properly.
2. Then connecting the appliance to power supply source.
3. Press the ON/OFF switch, the power indicator (red) is illuminated.
4.Turn the knob to the " " position, make sure the steam button is on the higher position which is
the" "position, the pump will pump water, when there is water flowing out, close the pump imme-
diately, pressing down the steam button to the lower position which is the " " position and waiting
for a moment, the appliance begins to be heated until the yellow lamp is illuminated, it shows the
heating is finish.
5. Remove the frothing device from the steam wand.
6. Dip the steam wand into the liquid to be heated. Turn the knob to the " " position.
7. When the required temperature is reached, you can turn the knob to the" " position.
8. Press the power switch to cut off the power source.
Automatically power-off function
1. After pressing power switch, if there is no any operation within 25 minutes, the unit will power off
automatically.
2. After pressing power switch, if there is no any operation after pump worked for 3 minutes during
brewing coffee, the unit will power off automatically.
13