Publicité
Les langues disponibles
Les langues disponibles
SYMPTOM
POSSIBLE CAUSE
Light will not
1. Light switch is turned off.
come on.
2. Bulb is loose or burned
out.
3. Fuse is blown or circuit
breaker is turned off.
4. Daylight turn-off is in ef-
fect (recheck after dark).
5. Incorrect circuit wiring, if
this is a new installation.
6. Re-aim the sensor to
cover desired area.
Light comes
1. Light control may be in-
on in daylight.
stalled in a relatively dark
location.
2. Light control is in Test
(Set control switch to an
ON-TIME position).
Please call 1-800-858-8501 (English speaking only) for assistance before
If you experience a problem, follow this guide. You may also want to visit our Web site at:
www.hzsupport.com. If the problem persists, call* for assistance at 1-800-858-8501 (English
speaking only), 7:30 AM to 4:30 PM CST (M-F). You may also write* to:
HeathCo LLC
P.O. Box 90004, Bowling Green, KY 42102-9004
ATTN: Technical Service
* If contacting Technical Service, please have the following information available: Model
Number, Date of Purchase, and Place of Purchase.
598-1234-04
All manuals and user guides at all-guides.com
TROUBLESHOOTING GUIDE
TECHNICAL SERvICE
returning product to store.
No Service Parts Available for this Product
SYMPTOM
POSSIBLE CAUSE
Light comes
1. Light control may be
on for no
sensing small animals or
apparent rea-
automobile traffic (Reduce
son.
sensitivity).
2. Sensitivity is set too high.
(Reduce sensitivity.)
Light stays
1. The sensor is pointed
on continu-
toward a heat source like
ously.
an air vent, dryer vent,
or brightly painted, heat
reflective surface (Reduce
sensitivity).
2. Light control is in Manual
Mode. (Switch to Auto.)
3. Light control is in
D
4. Sensitivity is set too high.
(Reduce sensitivity.)
Light flashes
1. Light control is in the Test
on and off.
mode and warming up
(Flashing is normal under
these conditions).
2. Heat being reflected from
other objects may be
affecting the sensor. (Re-
aim sensor.)
7
B
mode.
®
ual
rite
Publicité
