Gladiator CLAW GACEXXCPVK Instructions D'installation page 2

Parts Supplied:
#8 X 2" (5.08 cm) Wood screws (2)
Tools Needed:
Long, Phillips screwdriver
IMPORTANT:
Intended to be installed on ceiling joists. Mount the Gladiator
■
Claw™ Advanced Bike Storage v2.0 hook to either bare joists
or through drywall into the joist.
The Gladiator Claw™ Advanced Bike Storage v2.0 hook is
■
designed to hold the back wheel of a bike suspended from the
ceiling. To suspend the bike from both wheels, install two bike
storage hooks.
NOTE: To install two bike storage hooks, measure the distance
between the centers of the front and back wheels to determine
how far apart to mount the hooks onto the joist.
Maximum weight limit for a Gladiator Claw™ Advanced Bike
■
Storage v2.0 hook is 50 lbs (22.7 kg).
For warranty information:
In the U.S.A. call 1-866-342-4089 or visit our website at
www.gladiatorgarageworks.com
In Canada call 1-800-807-6777 or visit our website at
www.gladiatorgarageworks.ca
2
A
B
A. Mounting base
B. Wood screws
WARRANTY
B
C
1. Determine where you want to hang the bike and locate the
nearest wooden joist running in the desired direction.
2. Using the two wood screws (provided), attach the
mounting base of the bike storage hook to the
ceiling joist. Completely tighten both screws.
3. Press the plunger until the hook arms are in the open position.
4. Lift the bike up and press the bike tire against the plunger.
The hook arms will close around the wheel. Make sure
both arms are completely closed around the wheel.
5. Remove the bike by lifting the bike up and
pressing the tire against the plunger. The hook
arms will open to release the bike wheel.
D
C. Hook arm
D. Plunger