MEDintim ACTIVESinnflut Man Mode D'emploi page 9

Use
Avoid bending or a rotating of the silicone cover. This may cause
damage to the silicone cover or the Vibration elements. Use the personal
massager ACTIVESinnflut Man exclusively with water­based lubricants.
®
Use of oily silicone lubricants for long periods of time can lead to
permanent surface changes in the silicone cover.
To extend the life of the battery, the ACTIVESinnflut
sager comes with discharge protection that automatically switches off the
appliance when the minimum battery capacity is reached. Before automatic
shut down, short interruptions in Vibration indicate that you are approach­
ing minimum battery capacity. Recharge the personal massager in the
charging station after the automatic shutdown.
The personal massager ACTIVESinnflut
before use. Do not exceed the temperature range of 0° to +40° Celsius. The
capacity of the battery decreases as temperature decreases. Avoid sudden
temperature changes.
16
Man personal mas­
®
Man can be cooled or warmed up
®
Start-up and control
When manipulating the on/off key and control pin, switch them only
to the noticeable pressure point and the perceptible change of vibration.
Excessive effort on the controls can damage the personal massager.
Press the on/off key on the personal massager to switch
it on. The intensity of vibration rises briefly to maximum
strength after switching the personal massager on and
then drops back to the medium intensity.
To increase of the strength of vibration press the con­
trol pin toward "max". To decrease vibration, press it
toward "min". With individual pressure impulses the
vibration changes gradually through all 9 degrees of
intensity. If you keep the control pin pressed longer
than 1 second, the vibration strength changes inde­
pendently.
To run one of the 3 vibration programs, leave the con­
trol at maximum vibration strength for 3 seconds then
press the control towards maximum again, until you
feel the vibration change. You can change the program
by pressing the control towards "max" again.
To leave the vibration programs, press the
control toward "min".
on/off
17