Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Introduction:
Thank you for purchasing our product for the safety and comfort of your vehicle. Despite its
uncomplicated installation, we recommend that you consult a professional to avoid damaging your
vehicle.
Before installation:
- Comply with the rules in force in your country for the use and installation of this product.
- For your safety, please observe the following installation instructions.
- The monitor must be placed in a location that provides good visibility for the driver.
- The system operates on 12V DC voltage only, check the vehicle voltage, and the polarity of each
connector.
- Before installation, check that all vehicle components function correctly, such as contact, starter, light
code ignition and headlights... And carry out the same tests after installation. -
Connect the wires only by soldering or splicing. Bad contacts can create serious vehicle and system
malfunctions.
- Make sure that the system is properly grounded.
Camera
It is recommended to define the camera position according to the desired surveillance. Ideally at the
rear, centre or top of the vehicle. Drill a 16 mm hole for the cable to pass through in the center of the
desired camera position. Attach the bracket to the defined location, placing the seal between the
bracket and the vehicle. Adjust the camera on the bracket, adjusting your desired viewing angle,
replace the camera cover and tighten the 2 screws firmly.
Technical specifications :
Camera:
Viewing angle:
Sensor :
Resolution:
Sensitivity:
operating temperature:
Consumption:
Weight:
Dimensions:
Contents of the box:
1 extension cable -1 camera
2 YEAR WARRANTY
Product distributed by Antarès Diffusion, 185 Montée de Gravetan, 38 540 St Just Chaleyssin, France
150°
CCD
500 x 582 pixels
1 Lux
-20° to 70°C, RH 95% Max
140 mA
250g
133 x 60 x 215 mm
English
Publicité
Table des Matières
