Publicité
Les langues disponibles
Les langues disponibles
INSTALLING THE BLADES
Screws
INSTALLING THE MONTING PLATE
Light Wires
Adapter
plate A
Fig. 1
10
| hinkley.com
Blades
Blade
support
plates
Mounting Hub
(bottom of motor)
NOTE:
Remove any rubber supports that are installed for
shipping.
CAUTION: Remove the two rubber packing mounts from the fan
motor assembly and discard prior to attaching the blades.
Insert the blade through the slot on the housing. Align the holes
on the blade and the fan motor assembly and secure with the
blade support plates and blade attachment screws.
NOTE:
Cordless power screwdrivers are NOT recommended,
as they usually strip the heads of the screws and
usually will not fully compress the lock washers on
the motor screws. Use a large flat blade screwdriver
for final tightening to fully compress the washers. This
will help ensure proper alignment of the blades and
noise-free, wobble-free running.
NOTE: Be sure the power is off before installing.
Remove one of the three screws on the mounting hub
1
located on the fan motor. Loosen the other 2 screws. (Do
not remove) (Fig. 1)
Pass the light wires through the center hole of the adapter
2
plate A.
Place the key holes on the adapter plate A over the 2
3
screws previously loosened, turn the adapter plate until it
locks in place at the narrow section of the key holes.
Secure by tightening the 2 screws previously loosened
and the one previously removed.
Publicité
