Publicité
Les langues disponibles
Les langues disponibles
- Turn the unit off and unplug the power cord when the appliance is not in use, before clea-
ning and when changing the location of the appliance.
- Do not use the appliance where it can fall or push into the water. Never reach for the appli-
ance that has fallen into the water. Switch off the mains fuse immediately and unplug the
mains plug.
- Check regularly, but most definitely before every use, the mains cable and mains plug for damage.
- If any damage is visible, then further use of the unit must not be made.
- The appliance is not to be used by children or persons with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been supervision
or instruction.
- Disconnect the appliance from the mains before performing any maintenance work, by plug-
ging the plug or disconnecting the electrical system.
- If any damage and/or reduced functioning occurs, switch off and do not manipulate the unit.
- If, in such as event, a repair is necessary, contact an authorised by the manufacturer custo-
mer service point.
- Always take note of the general safety rules when using electrical equipment.
Maintenance/cleaning notes
- Before carrying out any cleaning or maintenance work, remove the plug or switch off the
electrical equipment!
- Clean the surface of the housing and the guard with a dry cleaning cloth and a damp brush.
- Do not use petrol or any similar light flammable cleaning material.
Storage
- If the fan is not to be used for some time, then store it in a dry room.
- In addition, you could put a cover on your unit to protect it from dust or dirt deposits.
Disposal
- Remove mains plug.
- Cut through the mains cable at the plug.
- Dispose of the unit in a proper manner.
Help with faults
Problem
The heater does not
work.
If the above information does not fix the problem, unplug the heater by removing the plug
from the wall socket.
In the case of a damage or breakdown, please leave the heater with a qualified electrician
to fix the problem.
If the power cord on the unit is damaged it may only be replaced by a repair facility autho-
rised by the manufacturer. Replacement of the power cord requires special tools.
Attention: Any repairs including replacing the halogen heating lamp should only be
carried out by a qualified electrician or by a recommended service center!
Suggestions for rectification
1. Check main and ancillary fuses. It should be an non-fast acting
fuse dimensioned for the maximum power of your heater.
2. Check heater for correct connection to the power socket.
3. Check the switch settings (On/Off) at the heater.
4. Check the correct installation of the heater (fig. F). If the
installation is incorrect, the device will not function if the
safety switch is permanently tripped.
EN
11
Publicité
