Sony WRR-861A Mode D'emploi page 13

1
Set the POWER switch to ON.
The display shows the same status as before the tuner
was last turned off.
If the group name and channel number is shown on the
display, skip step 2 and proceed with step 3.
2
Press the MODE button until the group and channel
number appear on the display.
3
Press the SET button.
The group indication starts flashing.
Group setting
Display example for 6668 model
4
Press the + or – button to select the desired group.
Pressing the + button cyclically changes the group in the
following order. Pressing the – button changes it in the
reverse order.
Note
After 30 seconds of non-operation period, the indication
stops flashing and the tuner exits the setting mode. The
item displayed at this time is stored in memory. Note
that this applies to all other item selection.
If you hold the button down, the group will continuously
change.
Model available in USA
Model available in Australia
9
(US)