Audizio RP335 Manuel D'instructions page 5

CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must
be returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately.
The arising condensation water might damage your device. Leave the device switched off until it has reached room
temperature.
1. Platter
2. Transit screw
System to protect the mechanical parts of the turntable during
transport. Rotate the screw clockwise completely to unlock the
turntable. Rotate counterclockwise completely to lock.
3. Tone arm lever
Use to raise/lower the tone arm.
4. Tone-arm clip
This arm clip secures the tone-arm while at rest or when not in use.
5. RPM switch
Controls the RPM (33/45/78rpm) of the record player platter.
6. Cartridge with needle
When the turntable is not in use, it is recommendable to place the
removable protection cover over the stylus.
7. Media player
A. Previous
Press to go to previous track (USB/BT).
B. Next
Press to skip to next track (USB/BT).
C. Play/pause / delete / on/off
Press to (re)start or pause play (USB/BT).
Double press to disconnect BT streaming.
Double press when playing a recorded file to erase/delete.
A beep will indicate a successful erasing.
Press and hold to put the device in standby mode.
Press to wake up the device.
D. Rec / mode
Press to switch modes (Phono/USB/BT).
Press and hold for about 2 seconds to enter record mode (when in BT- or Phono
mode and USB storage is inserted).
8. USB
USB slot for inserting USB storage devices up to 32GB (FTA32 version 2.0).
9. DC input
Connector for inserting the supplied 12V power adapter.
10. Speaker output
RCA speaker output connectors for connecting the supplied speakers.
11. Volume
Rotate to adjust the volume output level.
12. 45RPM adapter
This adapter allows you to play 45RPM records.
1. Connect the record player with the power adapter and plug the other end into a wall power outlet.
2. Gently remove the protective needle cover.
3. Rotate the volume control knob to just above the minimum level and turn on the power.
4. Select phono mode by pressing the mode button.
5. Place a vinyl record on the turntable platter and select the desired speed (33/45/78RPM) according to the record.
Use the 45rpm adapter if necessary.
6. Open the tone arm clip to release the tone arm. Push the lift lever backwards to raise the tone arm and gently move the
tone arm to the desired position over the record. The turntable will begin to spin when the tonearm is moved towards the
record. Push the lift lever forwards to lower the tone arm slowly onto the desired position on the record to start playback.
7. Rotate the volume control knob to adjust the volume.
5