Roller Grill 400 FE Notice D'utilisation Et D'installation

Instructions for use and installation
Electric crepe machine 400 FE
Description of the appliance
The 400 FE crepe machine is prefect for a use in small area due to their dimensions and
weight.
The 400 mm diameter plate allow you to made crepes and pancakes
This appliance is for professional use and must therefore be used by qualified personnel.
The identification plate is located on the back of the appliance.
Dimensions and capacity
Appliance Tension
400 FE 230 V
400 FE 110 V
Installation
Nota : The side panels of your appliance must not be placed next to a wall or partition made
from combustible material, otherwise, they must be covered in an effective heat insulating
material. A distance of 10cm from the partition is deemed sufficient.
Do not install your appliance close to a source of humidity or stream.
Before effecting the connection, check your main supply and its contact rating
Connect your appliance to a socket fitted with an earth.
304025 en ma 2013.04
*304.025 ELECTRIC CREPE MACHINE - MANUAL
Weight Current Power
input
16 kg 16 A 3600 W
16 kg 15 A 1650 W
Operation
Your crepe machine is fitted with a regulation thermostat and a temperature control pilot
light.
Before first use, it is important to remove with a detergent the anti-rust coating applied to
the griddle in the factory.
Pre-heat your crepe machine for about 15 minutes with the thermostat on maximum
position. Once pre-heating is finished, set the thermostat to the temperature required.
If slight traces of oxidisation appear, you can remove them with a metal brush.
Care and maintenance
Your appliance should be cleaned regularly with a damp sponge.
Do not clean your appliance under running water. Water entering the system might damage
it.
For improved service, we advise that periodic maintenance checks are carried out by a
qualified installer.