Settings; Wireless Channel Selection - Sony WRR-862A Mode D'emploi

1 2
BATT Lights Lights
indication
Good
Less than
BATT
50% charge
condition
Notes on batteries
•
Use new alkaline batteries.
•
Do not use different types of batteries together.
•
Always replace the four batteries together.
•
The batteries are not rechargeable.
•
Be careful to install the batteries with the correct polarity.
•
When not using the tuner for a long period, remove the
batteries to avoid leakage. If the batteries do leak, clean all
leakage from the battery holder case and the unit. Leakage
left in the holder case and the unit may cause poor battery
contact. If there seems to be poor battery contact, consult
your Sony dealer.
External power operation
To operate on an external power supply (DC 10 V to 17 V),
connect the DC 12V IN connector to the DC OUT connector
of a camcorder using the power cable supplied. When the
external power is supplied, the tuner functions regardless of
the built-in batteries.
3 4
Lights Flashes
Less than Almost
20% charge exhausted

Settings

To set the tuner in Setting Mode, press the SET button. The
indication on the display starts to flash waiting for you to
press the +/– buttons to change the contents on the display.
The Setting Mode is automatically cancelled if no buttons
are pressed for 30 seconds while the indication flashes.

Wireless Channel Selection

A RF B
SQUELCH
OFF ON
RF AF BATT
GP CH
2 CONTROL
1 2
POWER
OFF ON
1
Note
Noise may occur when the power is turned on or off. Be
sure to turn down the input level of the connected equipment
before operating the POWER switch.
3
A RF B
TX BATT
MONITOR
1 1+2 2
RF AF BATT
4,6,8
GP CH
MODE SET
5,7
7
(GB)