Publicité
Les langues disponibles
Les langues disponibles
8 screws at
back wall
Screw flange on
the 2"x4" stud
support
FIGURE 6
Wall Flange
Stud
Screw
Dry Wall
FIGURE 7: TOP VIEW SHOWING DRY WALL FINISHING
TROUBLESHOOTING
Base bottom section is not level: Refer to shimming
!
section on page 1.
Water remains around the shower base rim or drain:
!
Check that the installation is level and that the shower
base sits firmly on its base; use wood shim to correct.
We want you to be completely satisfied with our products and service. If you have any comments or suggestions, please call
The company reserves the right to change models and specifications without notice.
60 Shorncliffe Rd., Toronto, Ontario M8Z 5K1
Telephone: 416.231.9030
Dry Wall
800.MIROLIN(647-6546) toll free.
Fax: 416.231.0929
www.mirolin.com
TESTING
Test the installation after completing the plumbing, but
before enclosing the base and finishing the surroundings.
Run water for 15 minutes to ensure that there are no leaks at
the drain.
Mirolin Industries Corp. will not be liable for any kind of
damages as a result of not water testing the unit prior to use
by end user.
FINISHING
Apply trim around the shower base periphery to finish
!
drywall, if required.
Install Shower Door according to the manufacturer's
!
instructions if purchased
Mirolin Industries Corp. is not responsible for any damages
incurred as a result of poor installation of the product.
INSTALLATION CLEAN-UP
Remove construction dirt and residue with a mild liquid
detergent. DO NOT USE abrasive cleaners, scouring
compounds and pads, metal scrapers, steel wool, or other
materials that could damage or dull the surface of the bath.
Remove plaster carefully with a blunt wooden block having
rounded edges.
Remove paint and other stubborn stains with isopropyl
(rubbing) alcohol.
DO NOT USE products such as acetone (nail polish
remover), dry cleaning solution, lacquer thinners, gasoline,
pine oil, etc.
MAINTENANCE
The acrylic sheet, which forms the surface of your bathtub,
provides one of the most durable surfaces found in modern
bathrooms. Keep it bright and smooth with mild liquid
household detergent, soap and water, or foaming cleansers.
NEVER USE aromatic solvents, abrasive cleaners, scouring
compounds or pads, strong liquid cleansers, or other
material that could damage or dull the surface of the bath.
Restoring Surface Gloss.- Restore surface gloss by
applying a very fine rubbing compound and polishing the
surface by hand or with a power buffer. Finish with an
application of a good quality automotive wax.
Minor Repairs to Surface.- Remove minor scratches and
scuffs as follows. First, wet sand the area with 600 grit wet
sandpaper until the surface is smooth. Then, restore the
gloss as described under RESTORING SURFACE GLOSS.
Customer Service: 416.231.5790
Canada, U.S.A.: 800.MIROLIN(647-6546)
Fax, Canada: 800.463.2236
C
US
R0084152
28 Feb. 19
3
Publicité
