Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Problem
Item is leaking
Item is leaking
Motion detection is not working
Cause
Loose seal between quick-
connector
Not enough pressure
7
Solution
Thread the quick-connector
onto the water inlet of the step
spike. Then attach the hose-end
connector to the male-end of
the garden hose. Insert the
hose-end connector to the
quick-connector until a clicking
sound is heard.
Ensure there are no kinks from
hose and there is adquate water
pressure flowing into sprinkler
Run a dry test by turning the
detection mode to
waving your hand in front of
the sensor lens. You should
clearly hear the internal water
valve click open, and then click
closed 3 seconds later.
If this does not work, try a new
battery. The sprinkler resets 8
seconds after the valve closes if
the sensor does not detect any
further motion.
and
Publicité
