Royal Vaporex M 380 Mode D'emploi page 10

NOTE:
In order to ensure safe use, even in case of accidental
contact with liquids, the steam gun is insulated from the
electrical power supply (zero-volt system).
WARNING:
Do not hold the steam jet concentrated for too long on
a single spot.
RECOMMENDATION:
When cleaning surfaces with the steam gun, wipe the
surface dry afterward using a micro-fibre or cotton cloth
if necessary; this will also remove any excess moisture
for thorough cleaning. In order to control the steam tem-
perature and cleaning power at the surface, move the
steam gun closer to or further away from the surface.
Extension tubes
Depending on the task in hand, you can fit one or two
extension tubes.
Push the extension tube onto the connection nozzle as
far as it will go until you hear it click into place. Then
fit the switchable floor nozzle.
Switchable floor nozzle
The switchable floor nozzle is used for the cleaning of
large washable wall and floor areas. The floor nozzle
can be used either with or without a cloth cover. Sensitive
18
Operation and function
surfaces (wood, linoleum etc.) should always be cleaned
using the cloth supplied. Place the floor nozzle on the
cleaning cloth and pull the cloth under the clips at both
sides.
For cleaning stubborn dirt on less sensitive surfaces, the
brush fitting can be extended by pressing the setting
button.
RECOMMENDATION:
The cleaning effect of the cloth can be improved by turn-
ing and changing the cleaning cloth regularly.
To clean very dirty areas, move the cleaning nozzle over
the surface more slowly in order to increase the clean-
ing action of the steam.
WARNING:
The Vaporex is not suitable for cleaning unsealed wooden
floors, soft plastics or wooden furniture.
NOTE:
For packaging reasons, the floor nozzle is supplied with
a separate connection fitting. To use the floor nozzle,
push the connection fitting onto the rear side of the floor
nozzle until you hear it click into place (one-time assem-
bly procedure). The floor nozzle is now fully assembled.
Operation and function
Accessory adapter
Push the accessory adapter as far as it will go onto the
connection nozzle of the steam gun until you hear it
click into place. The accessory adapter remains locked
in this position. The accessory adapter can be removed
again by pressing the accessory connection button and
pulling the adapter off.
Concentration nozzle
The concentration nozzle is pushed directly onto the
accessory adapter until it clicks into place. It can be used
with various fittings (jet nozzle attachment, brush attach-
ment, 2-in-1 combi-nozzle), depending on the task in
hand.
RECOMMENDATION:
The concentration nozzle can be used with various fit-
tings for cleaning:
Inaccessible areas such as corners, joints, blinds, radia-
tors, WCs, taps, stainless steel, windows, mirrors, enam-
elled surfaces, stain removal.
Jet nozzle attachment
The jet nozzle attachment can be fitted directly to the
concentration nozzle. The jet nozzle attachment is fitted
by pushing and twisting, and removed by pulling and
twisting.
Brush attachment
The brush attachment can be fitted directly to the con-
centration nozzle.
Choose the right brush attachment for the task in hand.
The brush attachment is fitted by pushing and twisting,
and removed by pulling and twisting.
2-in-1 combi-attachment
Rectangular steam nozzle – The hand nozzle can be fit-
ted directly to the concentration nozzle. The rectangu-
lar steam nozzle is fitted by pushing and twisting, and
removed by pulling and twisting. The rectangular steam
nozzle can be used either with or without the cotton cover,
depending on cleaning requirements.
RECOMMENDATION:
Perfect for the care and cleaning of cushions, carpets,
car seats, bathrooms and kitchens.
19