Other Connections; Signal Led - AERMEC AERWEB300 Manuel D'installation

Other Connections

AERWEB300 allows other connections: "Power Ext.Modem", "Ext.Modem" , "Internal Modem" and "System Alarm", which are
not available at the moment and therefore must not be connected.
• SYSTEM ALARM =
• POWER EXT. MODEM =
• EXT. MODEM =
• INTERNAL MODEM =

Signal LED

AERWEB300 has some LEDs that indicate the status of the device. All the LEDs are on the same side as the connections. The model
with the integrated GPRS modem has a LED on the same side as the antenna connection.
During the initial step, further to the start up, some leds may blink till this phase comes to an end. This is normal and indicates
the start-up phase is regularly getting on
The table below indicates the meaning of each LED during normal operation.
LED Colour
ALARM Red
REC Yellow
Tx Yellow
Rx Yellow
System Red
Status Green
Power Green
GPRS Red
24
GB
5154650_03
State
On
On
Flashing rapidly and alternately
On
Flashing
On
Flashing briefly
Flashing slowly
Description
Alarm triggered in the RS485 line
System is recording data
RS485 communication enabled
System alarm
Operation OK, system events being run
System is powered
GPRS modem connected to the telephone line
GPRS modem not connected to the telephone line