GPO PASSION ED Mode D'emploi & Garantie page 13

Care, cleaning and maintenance
You can clean the optics of your product with the optical
micro-fiber cleaning cloth provided with your product, or by
using other lens cleaning equipment solely intended for optical
cleaning purposes.
Be sure to keep the optical surfaces clean and immediately
remove any dirt or oil debris caused by grease (finger prints), oil
or water spots to guarantee consistent optical quality.
To clean the exterior lenses of your product, be sure to first
remove any granular dirt or debris that may cause scratching
during the cleaning process. Be aware that rough granular dirt
particles must be removed with either an air bellows or a clean
hair brush. Otherwise, this may lead to damage of the optical
coating or scratches on your lens. Once large debris is removed,
slightly breath onto the optical surfaces to create a damp fog,
then use the dry optical cleaning micro-fiber cloth provided to
clean the lens surfaces. All other outside mechanical parts, as
well as the rubber armor, can be cleaned with a normal soft,
clean and slightly damp cloth. Please do not use the optical
cleaning micro-fiber cloth to clean the outside parts or the
rubber armor. This micro-fiber cloth must remain free of any
physical granular debris.
Proper strorage
After using the binocular it is recommended to store it dry, in the
case that came with your product, in a well-ventilated room, at
normal to low humidity levels, in normal room temperatures.
If you use your product in a region with high humidity, store
your product in an airtight container with a humidity absorption
aid to avoid any exterior fungus adhesion
Spare parts
If you need spare parts or accessories for your binocular, please
contact an authorized dealer or GPO GmbH.
EN