Makita UT120X Manuel D'instruction page 5

Switching on and off
Short-Time Operation
switching-on: press the on/off switch
switching-off: release the on/off switch
Permanent Operation
Switching-on: press the on/off switch and keeping it pressed, engage the lock button
Switching-off: press the on/off switch and let it go off again
Full Wave Electronic System
The UT120 is equipped with an electronic, realizes the following functions:
- Infinitely variable speed adjustment with the controller speed
Position I → slow
Position IIIIIII → fast
- load independent speed stabilisation
Working Instructions
Mixers have a M14 – internal female thread. Take always care for cleanliness of the thread and the rim.
Please hold up with a jaw wrench 22 to remove the paddle.
Care and maintenance
Before all works at the machine, make sure that the plug is off the mains socket.
Due to its design, the machine needs a minimum of and maintenance.
Nevertheless you should always observe the following:
- Keep the electric tool clean.
- Avoid any particle or part to penetrate inside the tool.
- If the machine is defect let carry out a repair only through an authorized service workshop.